Skip to content Emergency Call Button with DSC Alarm Transmitter

Original price $159.00 - Original price $159.00
Original price
$159.00 - $159.00
Current price $159.00

The ADC-EPB-DSC-V3.0 is a stationary emergency button with an DSC  transmitter for secure independent home care and senior living. The ADC-EPB-DSC-V3.0 emergency button grants caregivers real-time insight into each client's current conditions as well as potential emergency problems.

This device requires an account, your partner will need to work with you to add devices to your account.

Alarms247 offers DIY monitoring packages to support these devices.



3.6 in. x 1.45 in. (Diameter x Depth)

Black, ABS plastic base with slip-resistant feet. 2 x AAA batteries in housing, and switch for optional audible message on button press

Red, ABS plastic, spring-loaded push button top
Electronic Signaling

2-AAA Battery-powered filter circuit with integrated 433 MHz (crystal controlled) DSC-compatible transmitter with 64 minute supervisory interval

5 second tamper on power up

Sensing Interface Filtered, normally open (i.e., when not pressed), momentary contact switch
Battery Life Replaceable 2x AAA battery: 2+ years


To add the Stationary Emergency Button to the account using the Partner Portal:
  1. Log into the Partner Portal.
  2. Find the customer account.
  3. Click Equipment.
  4. Click Sensors.
  5. In Sensor Management, click Add a Sensor.
  6. For Sensor ID, enter an unused ID.
  7. For Zone Definition, select 15 (Emergency) or 26 (Non-Emergency).
  8. For Sensor Name, enter a name for the sensor.
  9. For Serial Number, enter the serial number found on the bottom of the device.
  10. Click Add Sensor.

Installation and testing

  1. Locate the sensor within 100 feet of the base station.
  2. Check the button for any visible defects or damage. If damage is visible the unit should be replaced.
  3. Locate the button on a flat surface in a visible location in the room.
  4. If the button is new, pull out the plastic battery tab located on the underside of the unit. The tab is not needed for use and can be discarded.
  5. If the audio message is not needed, ensure the On/Off switch is set to the “Off” position.

    Note: This switch does not turn off the unit or disable the wireless signaling; it only disables the audio message. This switch is located on the circuit board inside the unit.
  6. The button can be mounted on a wall by removing the rubber feet on the bottom and sticking to the wall with double-sided foam tape.



Shipping & Delivery

We ship from Canada with typical delivery times of 2-5 days to major centers. Most orders over $100 before tax ship FREE.